92 articles — sodium-ion cells, packs and the engineering behind them. Page 9 of 11.
Sodium-Ion in C&I Storage: Removing Fire and HVAC Cost
A cabinet in a cold yard or a hot roof does not need the same thermal system a lithium pack does.
Read more →Sodium-Ion BMS: Voltage Curves, SOC and Balancing
A sodium pack reports a jumpy state of charge, then trips on charge at −5 °C. Working through the two most common BMS complaints…
Read more →Designing a Sodium Module: Busbar, Compression, Thermal
Three module designs that looked fine on paper and failed in the field: a busbar sized for average current, a stack that lost…
Read more →High-Rate Pouch Sodium Cells: 60C Continuous, 150C Pulse
A pouch cell rated 60C continuous and 150C pulse buys you power density — and costs you thermal design, tab welding and pack…
Read more →18650, 32140 and 46145 Cylindrical Sodium Cells
From a hand tool to a light EV: how the choice between 18650, 32140 and 46145 cylindrical sodium cells follows the energy and…
Read more →Large Prismatic Sodium Cells: 50, 100, 160 and 190 Ah
How a 50, 100, 160 or 190 Ah prismatic cell changes the module build around it — busbar, preload, thermal and handling, in the…
Read more →Prismatic vs. Cylindrical vs. Pouch Sodium Cells: Which Fits?
Three projects, three form factors. The same capacity in a prismatic, cylindrical and pouch cell behaves differently in a pack…
Read more →Electrolytes and Binders for Wide-Temperature Sodium Cells
Salt, solvent and binder decide whether a sodium cell works at −40 °C. Four questions a cell engineer asks about the electrolyte…
Read more →Hard Carbon Anode: Why Graphite Fails in Sodium Cells
Sodium does not intercalate usefully into graphite. Hard carbon does the job, and its precursor decides cost, first-cycle…
Read more →
