Skip to content
New product 12 V 100 Ah sodium-ion truck starting battery, 1500 CCA, Group 31T See the launch →
← All tools
  1. 1Find a cell
  2. 2Check the spec
  3. 3Configure the pack
  4. 4Layout and BOM
  5. 5Runtime
  6. 6Cold weather
  7. 7Thermal
  8. 8Compression
  9. 9Cables
Next: Runtime →

Tools

Pack layout and BOM

Pick the cell, set the series and parallel count, give the space inside the case — see the packing, the spare room and the parts list behind it.

Home / Pack layout and BOM

A pack is a mechanical object before it is an electrical one. The cells have to sit in the case with room for busbars, insulation and the BMS, and the number that fits is often lower than the number the voltage and capacity asked for. This tool counts both, then lists what the build needs.

Cells needed = S × P · Cells that fit = layers × rows × columns · Spare = case volume − cell volume

Inputs

57 cells with confirmed dimensions.

S
P
Space inside the case
mm
mm
mm
mm

Air gap for the thermal path. Prismatic cells in a compressed stack normally use 0–1 mm; cylindrical cells need more.

Packing

—

 

Top · L × W
Side · L × H
  • Cells needed (S×P)—
  • Cells that fit—
  • Layout—
  • Cells only weigh—
  • Case volume—
  • Spare room—

Bill of materials — planning quantities

    Counts are planning quantities, not a quotation. They assume one flat layer stack, square packing and 1 mm between cells; a real build adds end plates, compression hardware, a case wall and clearance you may not have measured yet. Structure and case add roughly 25–45% on top of the cell weight — the figure above is cells only.