Only cells whose dimensions we have confirmed are listed. The biggest capacity comes first — pick the one your voltage and capacity target points at.
V
Taken from the datasheet when the cell lists one — otherwise set it here before the voltage maths.
—
What does it have to deliver?
Series sets the voltage, parallel sets the capacity. We round the series up and the parallel up — never down.
V
Ah
A
Used for the C-rate and the cable step further down the chain.
How much room is there?
Inside dimensions of the case, not the outside. We check the stack upright and laid down, and tell you which one packs more in.
mm
mm
mm
mm
The build
Everything below comes from the three answers above. Quantities are planning figures — end plates, compression hardware and case walls are counted, tolerances are not.
Does it hold up?
The same pack, checked against the four things that catch people out — how long it runs, how long it takes to refill, what the cold does to it, and whether the heat and the cable are still reasonable.
A
°C
Datasheet figures for the cold check
%
%
mΩ
m
%
Results appear in the panel on the right and travel with the enquiry. Full versions of each check live in the individual tools.
Weight is cells only — case, busbars, BMS and hardware usually add 25–45%. Voltage is the nominal figure from the cell datasheet; a full pack sits about 15% higher, so check the inverter input range.
We use one first-party cookie to remember your language and consent choices. No advertising or cross-site tracking is loaded unless you accept analytics. Read the privacy notice.