Skip to content
New product 12 V 100 Ah sodium-ion truck starting battery, 1500 CCA, Group 31T See the launch →
← All tools
  1. 1Find a cell
  2. 2Check the spec
  3. 3Configure the pack
  4. 4Layout and BOM
  5. 5Runtime
  6. 6Cold weather
  7. 7Thermal
  8. 8Compression
  9. 9Cables
Next: Thermal →

Tools

Cold weather check

What a pack still delivers at −40 °C, and whether it is allowed to charge there. Put your own datasheet figures in and the curve follows.

Home / Cold weather check

Cold slows every chemistry. Sodium-ion keeps more of its capacity than LFP and — the part that is often missed — it also accepts charge below 0 °C, where LFP and NMC normally have to be warmed first. Our own 220 Ah prismatic cell is rated to charge above −10 °C. The pack you sized at 25 °C is still a smaller pack at −30 °C, so the BMS has to know where that line sits for your cell.

Available Ah = Rated Ah × Retention(T) · Curve = linear between the three anchor points below

Inputs

Ah
V
°C
Datasheet anchors
°C

From the cell datasheet. Sodium-ion cells commonly charge down to −10 °C or lower — LFP is the chemistry that stops at 0 °C. Our 220 Ah prismatic cell is rated “above −10 °C”.

%

Typical sodium-ion with a hard-carbon anode sits at 65–75%. Replace it with the figure from your own cell datasheet.

%

Typical 82–88%. LFP at the same temperature is closer to 55–65%, which is why the comparison matters.

Cold performance

—

 

  • Available capacity—
  • Available energy—
  • Loss vs 25 °C—
  • Charging allowed—

The curve is linear between the two anchor points and 100% at 0 °C — a straight line, not a measured curve. Real cells flatten near 0 °C and fall faster below −30 °C, so treat anything under −35 °C as a datasheet question. Charging below 0 °C plates sodium on the anode: most cells need the pack above 0 °C before the charger is allowed to run, and the BMS must enforce it.