
Most sodium cells look identical on a datasheet and differ in the electrolyte. The salt, the solvent blend and the binder on the electrode decide low-temperature performance, gas generation and how long the cell lives. Here are the four questions we get asked most, answered without a marketing gloss.
1. Which salt — NaPF₆ or NaFSI?
NaPF₆ in a carbonate blend is the incumbent: cheap, well understood, adequate at room temperature. NaFSI is more thermally and hydrolytically stable and behaves better at low temperature and high rate, but it costs more and can attack the aluminium current collector unless the formulation is right.
Many commercial cells use a blend. If a supplier quotes only “sodium salt” without naming it, ask for the formulation sheet — it exists.
2. Why does the solvent matter more than the salt?
Low-temperature performance is mostly about viscosity and how the solvent shells the ion. Ester co-solvents and ether-based systems lower the desolvation barrier and keep conductivity up below −20 °C, at the cost of high-temperature stability or cost.
This is why the same cell format from two suppliers can differ by 15% capacity at −20 °C while both datasheets look conventional.
3. What does the binder change?
The binder holds the electrode together through volume changes during cycling. PVDF is standard but needs a solvent and has poor adhesion to some sodium cathode surfaces; water-based binders such as CMC/SBR are cheaper and greener but need tighter drying control.
A cell that fades early in a stack often has a binder problem rather than a cathode problem — the electrode delaminates and impedance climbs.
4. What should a buyer ask for?
Capacity at −20 °C and −40 °C at a stated rate. Gas volume after formation. Cycle curve at the intended depth of discharge. And the electrolyte family, at least in general terms.
If the answers stop at “wide temperature range”, the cell has not been characterised for your duty. Ask for the curves; they exist in the supplier’s files even when they are not on the website.
Formulation shows up as a voltage difference before it shows up as a rate difference: low-temperature cells of 50 Ah are specified at 2.85 V while the standard product of the same format sits at 3.0 V.
Where to go next
- Cell database — temperature and rate figures
- Low-temperature sodium cells
- Discuss a formulation for your duty
Questions we get asked about this
Does the electrolyte really change cold performance?
Yes. Solvent viscosity and the energy needed to strip the solvation shell decide how much capacity survives at −20 °C — often a 15% difference between two cells of the same format.
NaPF6 or NaFSI — which is better?
NaPF6 is cheaper and the incumbent; NaFSI is more stable and better at low temperature and high rate, but costs more and needs the aluminium passivation handled.
Can I ask for a specific formulation?
At volume, yes. Below that, the practical request is a cell characterised at your temperature window, with the curves supplied.

