Skip to content
New product 12 V 100 Ah sodium-ion truck starting battery, 1500 CCA, Group 31T See the launch →

Hard Carbon Anode: Why Graphite Fails in Sodium Cells

Home / News and Blog / Hard Carbon Anode: Why Graphite Fails in Sodium Cells
Hard Carbon Anode: Why Graphite Fails in Sodium Cells
15 Nov 2026

Graphite is the anode of the lithium era and the first thing that fails when you try to build a sodium cell with it: sodium ions are too large to enter graphite’s galleries in a useful way. The industry answer is hard carbon — a disordered carbon with pores and defects that store sodium on both sides of the potential window.

Why graphite fails

Graphite stores lithium between graphene layers. Sodium’s ionic radius is roughly a third larger, and the energetics of forming a stable sodium-graphite intercalation compound are unfavourable. Cells can be built, but the reversible capacity is too low to matter commercially.

What hard carbon does instead

Hard carbon — non-graphitizable carbon — stores sodium by adsorption in pores at higher potential and by insertion into disordered regions at lower potential. The result is a sloping voltage curve rather than graphite’s flat one, and a usable capacity that depends heavily on how the carbon was made.

Precursor Typical character Supply view
Biomass (coconut, bamboo, fruit shell) cheap, variable ash content local supply, quality varies by season
Resin / polymer consistent, higher cost stable spec, higher price
Pitch-based good efficiency, process control needed petroleum-linked pricing

First-cycle efficiency is where the money goes

Sodium is consumed building the solid electrolyte interphase on the first charge. Sodium cells commonly lose 8–15% of capacity to that step, and a hard carbon with poor surface chemistry can lose more. You pay for the cell, you keep the efficiency.

This is the number to compare between suppliers: first-cycle efficiency at a stated rate and temperature, measured on a full cell, not on a half cell.

What it means for a buyer

Ask which precursor, and whether the supplier controls carbonisation or buys finished hard carbon. A factory that buys carbon has less ability to fix a drift, and the drift will appear as a change in first-cycle efficiency between batches.

If your pack design is already frozen around a cell, qualify a second carbon source early — this is the part of the sodium chain where supply is thinnest.

How the anode shows up in the datasheet

You rarely see hard carbon named in a cell datasheet; you see its consequences. A sloping voltage curve instead of a plateau, a first-cycle efficiency below 100%, and a published SOC-OCV table so the BMS can estimate state of charge on that slope — a 10 Ah 32140 datasheet carries exactly that curve. If a supplier cannot provide an SOC-OCV table, the anode and the cell have not been characterised for BMS work.

Where to go next

Questions we get asked about this

Why canu2019t sodium batteries use graphite?

Sodium ions are too large to form a stable intercalation compound with graphite. Hard carbon stores sodium in disordered regions and pores instead.

What capacity does hard carbon deliver?

Published reversible capacities are commonly in the 300–350 mAh/g range, depending on precursor and processing.

Why does first-cycle efficiency matter commercially?

Because you pay for the whole cell and keep only the usable capacity. A 5-point difference in first-cycle efficiency changes the effective cost per usable Wh.

Products for this application

Sodium-ion Batteries 62 models · specs and sizes 10145138 Sodium-ion Cell, 10 Ah, Pouch single product · full specification

Have a specification question this article does not answer? Send it with the numbers you already have.

Request a quote

Part of

More guides in this group