Skip to content
New product 12 V 100 Ah sodium-ion truck starting battery, 1500 CCA, Group 31T See the launch →

Cold Storage Battery — Sodium-ion Backup in Freezer Rooms

Home / News and Blog / Cold Storage Battery — Sodium-ion Backup in Freezer Rooms
Cold Storage Battery — Sodium-ion Backup in Freezer Rooms
16 Nov 2026

A freezer room is the one place where a battery’s cold rating stops being a brochure line. The pack sits at −20 °C or below and has to work when the mains fails — which is often the moment the doors have been open and the load is highest.

−25 °Ctypical room temperature
Dischargeworks; charging needs warmth
Defrostthe largest current in the room
Outsideput the pack there if you can

What the load looks like

Application Load Autonomy needed
Cold room controller and alarms 0.3–1 kW 2–4 h
Evaporator fans and defrost 2–10 kW 1–2 h
Refrigerated truck APU 1–5 kW Shift length
Emergency lighting and doors 0.2–1 kW 3 h

Discharge and charge are different problems

Discharge to −40 °C is where sodium holds its advantage: capacity retention at −20 °C is far better than lead-acid and better than LFP. Charging is the limit — below the cell’s charge cut-off the BMS will refuse current, so a pack that sits at −25 °C cannot be recharged until it warms.

That is fine for a standby pack charged from the mains in a warm plant room, and a problem for a pack charged inside the freezer. The practical answer is either a small heater on a thermostat or locating the battery outside the cold envelope.

Sizing for a defrost cycle

Defrost heaters draw the largest current in the room and run on a timer. Size from the defrost peak times its duration, not from the average load, and check the pack’s continuous discharge rating against it.

Where it does not fit

Charged inside the freezer, daily. Any chemistry needs heating.

A generator that starts within seconds. The autonomy requirement, and the case for a premium pack, collapses.

Questions buyers ask

Will it work at −30 °C?

Discharge yes, with derating. Charging is blocked below the cell’s floor.

Can the pack live inside the freezer?

It can, but then it needs a heater or it cannot be recharged. Put it outside the cold envelope where possible.

How much autonomy for a defrost cycle?

Size the peak current first, then the hours. Defrost is minutes, not hours, at high current.

Is it safe in a food environment?

Yes, in a sealed enclosure suitable for wash-down. That is a housing question more than a cell question.

Where to go next

Products for this application

Low-temperature Batteries 18 models · specs and sizes Prismatic Cells 20 models · specs and sizes 14500 Sodium-ion Cell, 650 mAh, Cylindrical single product · full specification

Have a specification question this article does not answer? Send it with the numbers you already have.

Request a quote

Part of

More guides in this group