
Prussian blue analogue (PBA) cathodes are the cost play in sodium-ion: iron and manganese in an open framework, no nickel, no cobalt, and a synthesis route that scales. They are also the family where two suppliers’ cells can behave most differently, which makes them a sourcing problem as much as a chemistry.
The open framework, in one paragraph
The structure has large interstitial sites connected by wide channels, so sodium moves easily — good for rate. The same openness means water can sit in the lattice, and vacancies in the framework leave space that the structure would rather fill with something else.
Both defects reduce capacity and shorten life, and both are process-dependent rather than chemistry-dependent. That is why PBA cells vary so much between suppliers.
What a trader should test
Ask for water content, and for the first-cycle efficiency at a stated rate. Ask whether the cell is a “Prussian white” variant — partially charged during manufacture — and what that means for the shipping state of charge.
Run a 100-cycle check at your own duty before committing to a container. The fade rate on PBA varies enough that a datasheet is not a substitute for a sample.
What an end user should know
PBA is a reasonable choice for cost-first, moderate-cycle applications: backup blocks, low-utilisation storage, applications where the pack will be replaced before it wears out.
It is a poor choice for the project whose business case depends on ten years of daily cycling. The cycle numbers are real, but they are the lowest of the three sodium families.
The questions that sort suppliers
Which precursor route? What is the water content at sealing? What is the first-cycle efficiency and at what rate? Can you supply a 200-cycle curve at 0.5C and 25 °C?
Four questions, and the answers separate the factories from the repackagers.
Where to go next
Questions we get asked about this
Is Prussian blue cheaper than NFPP?
Usually, on raw material. Whether it is cheaper per usable cycle depends on the fade rate you measure, which varies widely between suppliers.
What is the main technical risk?
Water trapped in the open framework and vacancies in the structure. Both cut capacity and life, and both are process-controlled rather than chemistry-inherent.
What should I test before buying?
Water content, first-cycle efficiency at a stated rate, and a 100-cycle fade curve at your own duty. A datasheet alone will not separate two suppliers.

