Skip to content
New product 12 V 100 Ah sodium-ion truck starting battery, 1500 CCA, Group 31T See the launch →

Trolling Motor and Marine Battery — Sodium-ion for Boats

Home / News and Blog / Trolling Motor and Marine Battery — Sodium-ion for Boats
Trolling Motor and Marine Battery — Sodium-ion for Boats
16 Nov 2026

A trolling motor draws high current for hours, and a boat sits unused for months. That combination is what kills lead-acid, and it is where sodium fits.

12 / 24 / 36 Vby motor thrust class
40–50 Atypical trolling draw
Group 24/27/31the footprints boats are built around
−30 kgweight saved versus lead-acid

What the motor draws

Motor class Typical draw Pack that suits
12 V, 45–55 lb thrust 40–50 A 12 V 100 Ah
24 V, 70–80 lb thrust 35–45 A 2 × 12 V 100 Ah
36 V, 100 lb+ thrust 35–40 A 3 × 12 V 100 Ah
House loads (fridge, lights) 5–15 A 12 V 100–200 Ah

Brands commonly fitted: Minn Kota, MotorGuide, Garmin Force, Lowrance Ghost. The motor does not care about chemistry; it cares about voltage sag under load, which is where a sodium pack holds up better than lead-acid at the same nominal capacity.

How to size the pack

1. Estimate running hours. A day’s trolling is often 3–6 hours at 40–60% power, not full throttle. At 50% a 55 lb motor draws roughly 25 A.

2. Convert to Ah. 5 hours at 25 A is 125 Ah at the motor. Allow for the fact that you should not run past 80% depth: about 155 Ah of nominal pack.

3. Split the house load. Fridges, lights and electronics should not share the trolling bank if you plan to get home on the motor. Two separate packs is the safer arrangement, and it is why most bass boats run three or four batteries.

Footprints that matter

Most boats are built around Group 24, 27 or 31 lead-acid boxes. A sodium pack of the same footprint drops into the tray, but the weight difference changes trim on small hulls — a 100 Ah lead-acid set can weigh 30 kg more than the pack replacing it.

Charging on a boat

Outboard alternators are small. The reliable chain is an outboard, a DC-DC charger, then the pack; or shore power through a charger with a defined profile. A pack charged directly from a legacy shore charger set for lead-acid will not reach full charge and may sit at a voltage it should not hold.

Where this is the wrong purchase

A few weekends a year. If the existing set lasts four seasons and is cheap, the economics do not close.

Marginal wiring. A 24 V motor on thin cable has a voltage drop problem that a pack cannot fix — the cable has to change too.

Salt-water deck storage. Without a sealed, corrosion-resistant enclosure, any pack fails early regardless of chemistry.

Questions buyers ask

Can one pack run both the motor and the electronics?

It can, but then a long trolling day leaves nothing for the electronics. Two packs is the standard answer.

Will the motor’s low-voltage cut-off work?

Most trolling motors do not have one; the BMS protects the pack. Check the cut-off against the motor’s minimum voltage.

How much faster will the boat be?

Not faster — but the voltage holds better under load, so top speed stays closer to rated for longer as the pack discharges.

Can I leave it on the boat over winter?

Yes, at partial charge and disconnected. Cold does not damage a sodium pack at rest.

Where to go next

Products for this application

Marine & leisure 7 models · specs and sizes Lead-acid replacement 78 models · specs and sizes PL-A889 72 V 80 Ah battery — yacht, bamboo raft and kart single product · full specification

Have a specification question this article does not answer? Send it with the numbers you already have.

Request a quote

Part of

More guides in this group