
A boat lift motor pulls a heavy load for two minutes, twice a day, at the end of a dock where nobody wants to run mains cable. Then it sits through winter.
What the lift draws
| Lift capacity | Current | Voltage | Pack |
|---|---|---|---|
| 3,000–4,000 lb | 80–150 A | 12 V | 12 V 100 Ah |
| 6,000–8,000 lb | 150–250 A | 12 V / 24 V | 12 V 200 Ah or 24 V 100 Ah |
| Dock lighting and pedestal | 2–10 A | 12 V | 12 V 50–100 Ah |
How to size the pack
1. Lift energy per cycle. Two minutes at 150 A is about 5 Ah. Ten cycles a weekend is 50 Ah — the pack is sized by reserve, not by daily energy.
2. Solar or shore top-up. A 100 W panel covers lights and standby but not a heavy lift weekend. Shore charging once a week is the practical arrangement.
3. Cold margin. In a winter marina the pack may sit at −15 °C for weeks; capacity is there, charging is not.
Salt air and water
The enclosure matters as much as the chemistry. A sealed box with a proper gland and a UV-stable lid is the requirement; a vented plastic case in salt spray fails in a season regardless of the cells inside.
Winter
Docks in freezing regions see −20 °C. Discharge is fine, charging is not — a pack charged only by a dock solar panel will stop charging in deep winter. That is acceptable for a lift that is not used in winter, and a problem for one that is.
Where it does not pay
Mains already at the dock. A lead-acid block is cheaper to replace than to redesign.
A lift used twice a year. The pack will outlive its usefulness.
Questions buyers ask
Can solar keep it charged?
For lights and standby, yes. A heavy lift weekend needs shore charging or a bigger array.
Will it survive salt spray?
With a sealed enclosure and marine hardware. The connector is the usual failure point.
Can it stay out all winter?
Yes at partial charge, disconnected. Do not expect it to charge below freezing.
What about a 24 V lift?
Use a 24 V pack or two 12 V in series. Series packs need a BMS that balances at string level.

