
A camper battery lives a strange duty: deep discharge in summer, months at float in winter, and a charging system built for lead-acid. Sodium handles the first two better than lead-acid and needs the third one checked.
What the van actually needs
| Use | Typical pack | What decides it |
|---|---|---|
| Weekend camper, 12 V fridge | 12 V 100 Ah | Fridge duty, 25–45 Ah/day |
| Full-time van life | 12 V 200–280 Ah | Inverter load and solar input |
| Class A motorhome | 2 × 12 V 200 Ah | Residential fridge and AC |
| Winter storage | Same pack, lower SOC | Temperature at the storage site |
Brands we quote against most often: Winnebago, Airstream, Thor, Jayco, Forest River, Coachmen, and self-builds on Sprinter, Transit and Ducato platforms. The van brand rarely changes the battery — the charging system does.
How to size the bank
1. Add up the daily load. A 12 V compressor fridge is the largest item at 25–45 Ah/day. Lights, pumps, charging and a laptop add 10–30 Ah. An inverter for a kettle or an induction hob changes everything: 1,000 W for 15 minutes is roughly 21 Ah at 12 V.
2. Divide by usable depth. A 200 Ah pack at 80% depth gives 160 Ah usable — about three days of fridge and lights with no sun.
3. Check the recharge side. Solar in winter produces a fraction of its summer output, and the alternator only charges while driving. If the van sits for a week, the array decides the pack size, not the other way round.
The charging problem
A sodium pack wants a defined absorption voltage and then to stop. A vehicle alternator, a solar controller set for lead-acid, and a shore charger set for AGM all deliver different profiles. The practical fix is a DC-DC charger between the alternator and the pack, plus a solar controller with a lithium/sodium profile.
This is the single most common reason a camper swap disappoints: the battery is fine, the charging chain is not.
Cold nights
Discharge to −40 °C is the headline, and it matters for a van parked in the Alps in January. Charging is the limit: below the cell’s charge cut-off the BMS will refuse, so solar charging on a freezing morning will not start until the pack warms — which in practice means a small heater pad, or charging once the van is running.
Where it does not make sense
A hook-up camper. Nine months on a trickle charger and one week at a site with mains does not need cycle life.
A weight-critical build. Where every kilogram is counted, LFP packs more energy into the same space.
A van with a fixed lead-acid charger. If the charger cannot be reprogrammed and cannot be replaced, the swap becomes a compromise.
Questions buyers ask
Can I charge from the alternator directly?
Not reliably. Modern vehicles vary the alternator voltage for fuel economy, which can sit below what the pack needs. A DC-DC charger is the usual answer.
Will my solar controller work?
If it has a lithium or user-defined profile, yes. A lead-acid-only controller will undercharge.
How long will a 100 Ah pack run a fridge?
At 35 Ah/day, roughly two days at 80% depth of discharge with no input. Add solar and it becomes continuous in summer.
Is it safe inside the van?
Yes, with a proper enclosure and venting to the outside. Treat the installation like any lithium-family pack: fuse the positive, and ventilate.
What about winter storage?
Leave it at partial charge, disconnect the loads, and charge before the first trip. It will hold charge better than lead-acid through a cold winter.

