Skip to content
New product 12 V 100 Ah sodium-ion truck starting battery, 1500 CCA, Group 31T See the launch →

Refrigerated Van Battery — Last-Mile Delivery Cooling

Home / News and Blog / Refrigerated Van Battery — Last-Mile Delivery Cooling
Refrigerated Van Battery — Last-Mile Delivery Cooling
16 Nov 2026

A refrigerated van has two batteries doing two jobs: the vehicle battery that cranks the engine, and the pack that runs the refrigeration unit while the engine is off at a delivery stop. The second one is where sodium-ion earns its place, because it is cycled every day and it sits in the worst thermal position in the vehicle.

The cooling duty, in numbers

A last-mile box body loses cold every time the door opens. The refrigeration unit has to pull the box back down while the driver walks to the door, and it has to hold temperature through a queue of stops. The energy that takes is set by box volume, insulation, ambient temperature and the number of door openings — not by the vehicle.

Duty Typical continuous load What it means for the pack
Standby at the kerb, doors closed 0.5–1.2 kW Dominated by insulation, not by stops
Door-open recovery 1.5–3 kW for a few minutes Sets the peak current, and the BMS cut-off
Full shift, engine off between stops 3–8 kWh per day Sets the pack capacity and the recharge window

Treat these as planning figures. The honest way to size the pack is a datalogger on the unit for one week, which is cheaper than over-buying capacity by 40%.

Why not just idle the engine?

Idling a diesel for cooling is the default because it is simple, and it is increasingly restricted in city centres. A pack that runs the unit with the engine off removes the idle, cuts fuel burn on a dense route, and keeps the box cold through a stop where the engine has to be shut down anyway.

Heat is the real enemy, not the cold

The pack usually sits under the body, next to the condenser, in a compartment that sees ambient plus radiant heat. Sodium-ion cells tolerate that better than a lithium pack held at high state of charge, but the design still has to do two things: keep the pack out of the condenser air path, and give the BMS a temperature input that measures the cells rather than the compartment.

Where sodium does not fit

If the van already carries a large alternator and a second alternator dedicated to the fridge, adding a pack may not pay back inside the lease. If the unit is a eutectic holdover system, the cooling is stored in the plate rather than in a battery, and the pack only has to drive the compressor during the drive cycle — a much smaller job.

What we need to quote

Questions buyers ask

Can the pack be charged from the alternator while driving?

Yes, through a DC-DC converter sized for the pack voltage. The converter is part of the specification, because a 12 V alternator cannot charge a 48 V pack directly, and the recharge window between routes is usually the limiting factor.

Does the pack need heating for winter routes?

Discharge down to −40 °C is not the problem; charging below zero is. For northern routes we specify either a heated pack or a charger that holds charge until the cells are above the limit. Tell us the coldest overnight temperature the van sees.

What documentation travels with the pack?

UN 38.3 test summary, MSDS and the dangerous goods declaration, because a refrigerated van pack is still Class 9 when it ships separately as a spare.

Products for this application

Lead-acid replacement 78 models · specs and sizes ZB-1204 12.8 V 4 Ah lead-acid replacement battery single product · full specification

Have a specification question this article does not answer? Send it with the numbers you already have.

Request a quote

Part of

More guides in this group