
A jump starter is a power device, not an energy device: hundreds of amps for three seconds, then it sits in a boot for a year. Wh matters less than what the pack can deliver at −20 °C.
What the pack has to deliver
| Engine | Cranking current | Cell build |
|---|---|---|
| Petrol 1.6–2.0 L | 200–300 A | 3–4 × 18650 high-rate in parallel |
| Diesel 2.0–3.0 L | 400–600 A | 6–8 × 18650 high-rate |
| Truck / marine | 800–1,200 A | Larger pouch or many cells in parallel |
Our own high-rate cells in 18650 format: 900 mAh at 20C and 850 mAh at 35C, both quoted for 1,000 cycles at 1C and 25 ± 2 °C. A 35C cell of 850 mAh delivers roughly 30 A continuously and far more as a pulse.
How to size the pack
1. Start from the engine. Petrol up to 2.0 L needs about 300 A; a 3.0 L diesel can ask for 600 A. Take the peak, not the average.
2. Divide by the cell’s pulse rating. If the chosen cell delivers 40 A for the pulse duration, 600 A needs at least 15 cells in parallel — plus margin for cold, which reduces what each cell gives.
3. Check the board, not just the cells. The protection board’s continuous and peak ratings must exceed the pulse. Most “failed” jump starters are boards that gave up, not cells.
Why not lead-acid
A small lead-acid block that could deliver 600 A would weigh several kilograms and lose most of its punch at −20 °C. The whole category exists because high-rate lithium-family cells made a pocket-sized booster possible — sodium adds the cold margin and the tolerance for being left flat.
Design details that decide reviews
Reverse-polarity protection, a pre-charge on the output, and a board that survives being connected to a completely dead battery. Those three decide whether a product gets returned, far more than the cell specification does.
Where sodium is not the answer
A price-led product. At small volumes the cheapest lithium cell will usually win on cost.
A booster that is never recharged. Sodium tolerates deep discharge better than lithium, but a pack left flat for two years will still fail.
Questions buyers ask
What does 35C mean for a 850 mAh cell?
About 30 A continuous, and considerably more as a short pulse. Pulse ratings always carry a duration and a temperature limit.
How many cells for a 3.0 L diesel?
At least 15 in parallel at 40 A pulse each, with margin for cold. The board rating has to match the sum.
Will it work at −20 °C?
Yes for discharge; charging below the cell’s floor must be blocked. A booster used in winter is charged indoors.
Can it start a vehicle with a completely flat battery?
Usually yes, but the surge into a dead battery is the hardest event the board will see. Pre-charge protection is what makes it survivable.

